Lpc2000

Hello All,
   When I run my UART code on Keil, it works fine. But when I run the same code on this compiler, choosing the startup file provided by it, I don't see my output on the hyper terminal.
I also tried using the simulator, it goes to this instruction:

ldr pc, [pc, #dabort_handler_address - . - 8]

and then jumps to
 dabort_handler:  b dabort_handler and remains there.

Can anyone help?

Vineet.


		
---------------------------------
Yahoo! Mail
Bring photos to life! New PhotoMail  makes sharing a breeze. 

[Non-text portions of this message have been removed]

Hello Vineet,

The reason is that Rowly's simulator only supports core ARM instructions. This means that load and store (access memory) instructions cannot be simulated. But I have been told that if you do it with in circuit debugging, then it will work. I guess that they will implemement the simulator in a later release.

Kind regards,

Henk

  ----- Original Message ----- 
  From: vineet jain 
  To: lpc2000@yahoogroups.com 
  Sent: Sunday, March 12, 2006 15:40
  Subject: [lpc2000] Evaluation Crossworks


  Hello All,
     When I run my UART code on Keil, it works fine. But when I run the same code on this compiler, choosing the startup file provided by it, I don't see my output on the hyper terminal.
  I also tried using the simulator, it goes to this instruction:

  ldr pc, [pc, #dabort_handler_address - . - 8]

  and then jumps to
  dabort_handler:  b dabort_handler and remains there.

  Can anyone help?

  Vineet.


              
  ---------------------------------
  Yahoo! Mail
  Bring photos to life! New PhotoMail  makes sharing a breeze. 

  [Non-text portions of this message have been removed]



  SPONSORED LINKS Microcontrollers  Microprocessor  Intel microprocessors  
        Pic microcontrollers  


------------------------------------------------------------------------------
  YAHOO! GROUPS LINKS 

    a..  Visit your group "lpc2000" on the web.
      
    b..  To unsubscribe from this group, send an email to:
     lpc2000-unsubscribe@yahoogroups.com
      
    c..  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


------------------------------------------------------------------------------



[Non-text portions of this message have been removed]

>>    When I run my UART code on Keil, it works fine. But when I run 
the same code on this compiler, choosing the startup file provided by 
it, I don't see my output on the hyper terminal.
I also tried using the simulator, it goes to this instruction:

ldr pc, [pc, #dabort_handler_address - . - 8]

and then jumps to
  dabort_handler:  b dabort_handler and remains there.

Can anyone help?  <<

Do you have the appropriate pull resistors connected and have you got 
the checksum correct?