MOTM

Larry and Ken have done great work on their FPs, and Ken's "how to make a 
custom MOTM FP" page is very thorough -- I haven't done any MOTM diy stuff 
yet (since I have too much MOTM for my already full rack and I want to build 
a REAL cabinet when those flat rack rails are ready -- hint). When I do some 
diy MOTM stuff, I'm going to follow Ken's directions, though I am interested 
in what Moe's got going.


In a message dated 5/10/2000 8:05:05 AM, blacet@... writes:

>Excellent lettering job on the MOTM/Blacet Mixer. It even says "Blacet
>Research..." on the bottom. Now I'm scared because people will think
>this is a standard product!

There was recently an offlist discussion about how we might label our 
(non)MOTM panels -- how about adding one word: "CUSTOM" in front of Blacet 
Research?



In a message dated 5/9/2000 6:40:27 PM, shemp (who takes his horticultural 
taxonomies seriously) writes:

>Alright Paul.  Here it is again!  And Blacet is in on it this time doing
>everything he can.  The first colaboration module!!!  Make up a front panel
>and supply the extra MOTM-certified parts to complete the set-up.  I'll
>take
>2 of these special kits just to get the ball rolling!  $40 each?

In a message dated 5/9/2000 7:05:53 PM, tentochi@... writes:

>I meant a Synthesis Technology manufactured front panel and appropriate
>jacks, pots, etc.  All the way up to full MOTM spec on the extra parts.

Unfortunately I think that Larry and Ken paid a lot more than $40 each to get 
their Blacet modules to look MOTM. I'd bet it was closer to $70 (6 pots/knobs 
X $7.50 + 6 1/4" jacks X $1.50 + FP + graphics + brackets).

But someone should think about this!
JB