MOTM

In a message dated 00-07-03 21:55:19 EDT, you write:

<< Let me know what you want to do Dave. >>


john,
i`m not sure what you meant by this - ?  did you want a copy of the peak / 
trough schematic ?  it is very simple and would be a good  d.i.y.  project.
from years back, when i built my late lamented serge, i ,too, found it tricky 
to get the panel graphics on nicely. i ended up sticking on the top edge then 
gently peeling down and following over it with a roller ( i used a "d" cell 
for the smaller modules and bought a length of dowel to cut to 3 and 4 spaces 
for the larger modules ). this seemed to work pretty well as far as surface 
contact and getting rid of air bubbles.
re : other graphics you might have - well, you could kludge up a vcf from cem 
chips that would pretty much match the vcf but for the more esoteric modules 
like the "dsg" i`m not sure that would work.
best,
dave v.