MOTM

Well, it is exciting to me.

My web site is now accessible again and improved while it was gone.
Access it at http://24.12.85.234/larry

Here is what is new:
- VISIO templates for MOTM modules from Fred Beecher
- New faster loading GIF format schematics
- 822 and 831 builders FAQ.  All e-mailed questions will get added to this.
- Users forum - this is a place I am making available for users who
   want to share those great photos or MP3s or whatever and need
   a nice place to have them available to the group.  No stinkin' Yahoo
   password required.  If you want to have your stuff here, just e-mail me.

Update on 822 and 831 instructions -
 - Calibration instructions are finished and the beta tester says GO.
   So, I will be giving them one additional proof reading and will 
   post them.
- 822 assembly instructions are finished and proof read by me.  They go
   out for a second opinion this weekend and will be used to actually
   construct one 822 to check them for usability.
- 831 instructions are almost finished - I need a volunteer to look
   these over.  My 822 tester does not have an 831

All of these instructions shoud be ready for down load early next week.

More good news.  I have several people interested in 822 PCBs.  If I get
just a few more, we have a second run.  Price will be the same.  They will
have solder-mask this time.

Some bad news - the brackets are GONE.  Unless you have been one
of the 3 or so people who ordered in the last couple of days, it is now 
too late.  However, I think everyone who wanted them and needed 
them did get them.  I will consider another run if there is enough demand.
 However, I cannot buy less than 200 at a time.

Larry Hendry