MOTM

2 of my drill locations are identical to your last two on this list.  One
alternative is right next to the power connector (as close as you can get it
to fit, between "com" and "com"

As far as the front of the board, I am using the existing holes that were
provided for the pot mounting brackets.  Only one connects to a trace (avoid
that one).  The others are free.  I am using # 2-56 nuts and bolts too so
the holes can stay small.

That's my $.02
Larry H


----- Original Message -----
From: <improv@...>
However, it's too late for me and my Time Machine. So, I'm looking for
suggestions about where to dril the holes to mount it to my brackets.
Looking for spots with no components or traces, I've found the following
locations:

Between R1 and R2, in the upper left corner of the board
Between R3 and R4, in about the middle of the left edge of the board
Between D3 ands RN8, about the middle of the bottom edge
To the right of U15, about 1/3 of the way down the right edge

My question, to John or anyone else building the Time Machine in a MOTM
package, is, will I seriously screw up anything if I drill in these
locations? Any better suggestions?