OBERHEIM SYNTH

Hi, Oberheimers!
 
Hmmm... Can't understand the problem.  I have a Matrix-6 and -6R, and the Split keyboard Stereo outputs work flawlessly on both.
 
Perhaps you could try the headphone output to check for a stereo split?
 
Oh, and make sure that you haven't accidentally assigned zero voices to one side or the other!  Oberheim implemented this to enable one to play another synth via MIDI without using any of the Matrix's internal voices.  Voice Allocation settings are in the SPLIT section of the Matrix.
 
At any rate, Best of Luck with it!
 
Dave Garfield - Matrix-holic

From: Les Lambert <les_lmbrt@...>
To: "oberheim@yahoogroups.com" <oberheim@yahoogroups.com> 
Sent: Wednesday, October 30, 2013 9:09 AM
Subject: Re: R: RE: R: Re: [oberheim] Re: matrix 6 stereo outs

  
I couldn't get it to work on my Matrix 6 either, so bought a Matrix 1000.Stereo without tears. 

On Wednesday, 30 October 2013, 9:24, "ste.mari@..." <ste.mari@...> wrote:

  
hi Johan
thanks for write me, I know what manual say but it didn't work on my M6r and M6
if you can obtain sounds from the two out please write me
ciao


  
>Hi Martin,
>
>
>I recently bought a M6r and on page 11 in the manual it says that you have to set param 56 in Master mode to Stereo "ON" and then the right jack will output the upper sound in Split mode. Have not tried it myself as I only have one input to spare for the M6r.
>/Johan 
>---In oberheim@yahoogroups.com, <ste.mari@...> wrote: 
>I tried this as for manual many times on my M6 and M6r, even through soundiver but I never could listen
>any sound from right jack. I I thought it would be interesting to have two different patches at the same time
>Martin
>
>
>
>
>>>  
>>>My bad it was actually on page 10 
>>>"When stereo is set to on, the left/mono jack outputs all sounds from single patches and the sound from the lower patch when in split mode; the right jack only outputs sound when in SPLIT mode, and this sound comes from the upper patch"Thanks and sorry I just downloaded the manual from the files area, 
>>>Jason
>>>On May 19, 2013, at 4:12 PM, "elwro07" <elwro07@...> wrote:
>>>  
>>>>Well, have you read the owner's manual ?Everything about the outputs is explained on page 8.--- In mailto:oberheim%40yahoogroups.com, "Jason Budris" <jsunbud@...> wrote:>> I just purchased a used matrix 6 and am wondering why when I hard pan left i get no sound. Is it a bad out you think?> > Thanks,> Jason>
>>>
>>
>>
>