Greetings, I just picked up two m1000's and immediately connected them using group mode. It all seems to work *except* bank changes are not being received by the slave - it's as if bank lock was enabled on the slave unit(but it's not). so far I have: combed through the manual ;) reinitialized both units swapped the cables to change the master/slave relationship searched through the message archives here no luck! any ideas? I imagine it's just simple user error Thanks, john PS: I have the m1000's plugged into an ensoniq dp4 - 4u of pure delight, and I haven't started programming yet!
Message
new m1000 owner - and, of course, a question.
2006-09-29 by evening_soundgate