Discussion about the Korg PolySix synthesizer

I'm currently repairing a battery-damaged CPU board, and I've just about 
got everything working again -- except for the LFO bleedthrough into the 
VCO modulation circuit.

I've repaired over three dozen of these things the past few years, and 
come across this problem repeatedly.
I was able to solve it several times in the past by cutting the circuit 
board trace at CNO6-2 and at the outside end of R9, and joining them 
with a jumper (taking care to move C43 back into the circuit).  This 
bypassed the parts of the circuit board that caused the LFO signal to 
bleed into the modulation circuit even when the mod wheel was fully down.

In the case of this board, however, that procedure isn't helping -- 
there's still LFO modulation audible on the VCO (and visible on the 
scope at R9).   I though it might be something from the other LFO mod 
path from the front panel mod switch (through ICs 1 and 2, finally 
through R11), but grounding that signal doesn't stop the mod effect.  
And, it's only appearing at the VCO mod circuit;  no sign of it at the 
VCF or VCA.

Thinking it might be something on the front panel, I swapped in a 
working CPU board, and the problem went away;  obviously the fault is in 
the first CPU board.

My eyes are starting to blur going over these schematics;  has anyone 
here dealt with this problem successfully?
If so, I'd love to hear about it.

Thanks.
~GMM