>
> Hi Milan,
>
>
>
> If the VCO has stopped working then it is no wonder there are problems with
> the tuning and mod wheel! Just remind me, were you the person who was having
> problems with the battery running flat on the '367 after it was repaired? I
> really think the guy who repaired this should really take a second look at
> it for you. If you want to have a go yourself take a look at the switching
> action at IC29 pin 11 and pin 13 of the comparator IC3. But I would address
> these issues before you start digging in the far left-hand corner of your
> P6!
>
>
>
> Cheers,
>
> Andy
>
>
>
>
>
> From: PolySix@yahoogroups.com [mailto:PolySix@yahoogroups.com] On Behalf Of
> Mekonin
> Sent: 30 November 2009 17:31
> To: PolySix@yahoogroups.com
> Subject: [PolySix] Re: Master tune + Mod wheels not working
>
>
>
>
>
> Hi Andy,
>
> ok so I tested the MG section. It works when put to VCF and VCO, but when
> it's on VCO it has no effect whatsoever.
>
> Milan
>
> --- In PolySix@yahoogroups.com <mailto:PolySix%40yahoogroups.com> , "Andrew
> Jury" <andy@> wrote:
> >
> > Hi Milan,
> >
> >
> >
> > Can you tell us if the MG section of your Polysix is in full working
> order?
> > Particularly the modulation routing switch (VCA, VCF, VCO)? This may have
> a
> > bearing on the problem if it is not.
> >
> >
> >
> > Thanks,
> >
> > Andy
> >
> >
> >
> > From: PolySix@yahoogroups.com <mailto:PolySix%40yahoogroups.com>
> [mailto:PolySix@yahoogroups.com <mailto:PolySix%40yahoogroups.com> ] On
> Behalf Of
> > Mekonin
> > Sent: 29 November 2009 09:48
> > To: PolySix@yahoogroups.com <mailto:PolySix%40yahoogroups.com>
> > Subject: [PolySix] Master tune + Mod wheels not working
> >
> >
> >
> >
> >
> > Hello fellow Polysix lovers,
> >
> > I am writing this in need of your help once again.
> >
> > Few weeks ago my P6 started acting funny, it was detuned down for a whole
> > octave and a half, and I noticed that master tune knob and mod wheels have
> > no effect on the sound. I opened it up, saw if there are any loose cables,
> > put it in test mode and back again, and when I returned it to "Normal", it
> > was working as it should. But next time I powered it on (or the second
> time
> > I can't remember), after some playing I noticed that the pitch was
> drifting.
> > I tried the tune knob and mod wheels and realised that they are not
> working
> > like that time before. This time, fiddling inside the P6 did not help.
> > If you have any suggestions what might be the problem, please write.
> >
> > Thank you all in advance,
> > Milan
> >
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>
>
>
>
> [Non-text portions of this message have been removed]
>
