Sequential circuits samplers

I know this is an old thread but I was curious if it is possible to route say the filter 
frequency to the aftertouch or modwheel?  Or map the FF to any other controller(breath, 
footpedal) for that matter?  If so how would you do it?

Thanks
Brian



--- In prophet2000@yahoogroups.com, "ferrograph632" <ferrograph@...> wrote:
>
> >>I think you're right. Volume- pitchbend and mod might be its limits.<<
> 
> don't forget "aftertouch".... I think you can map channel pressure to
> a couple of things... it's been a while, but I suspect it's mapped to
> the same destination(s) as the mod wheel though.
> [digs out manual...]
> yes, controller numbers 01 (mod wheel), 02 (breath controller), 03
> (channel pressure) & 04 (foot pedal) all seem to be mapped onto
> whatever the mod wheel is doing. 
> other recognised controllers are 07 (obviously- over-rides front panel
> volume, which may not be so obvious), 40 (hold), 45 (alternate
> release) & 7A (local on/off). these are all in hex. oh, & the usual
> preset selection & pitch wheel.
> 
> it's limited, yes, but sometimes this is a good thing. for instance, I
> made a lot of patches with velocity crossfades in them.....
> 
> >>For a 20 yr old sampler it still is great sounding.<<
> 
> it is, after all, almost equivalent to a prophet five in it's main
> architecture, only with a sample-playback front-end instead of
> oscillators. I have stacks of emu stuff, but the p2k & p2002 just
> sound better. every time I load a floppy into it, I am amazed by the
> musicality of the noise that comes out.
> 
> duncan.
>