Vintage Synth Repair

Thanks a lot. That was exactly what I wanted to know. The LED came out quite
easily - I wonder how hard is to get a new one in :)

Thanks again,
Margus

----------------------------------------------------------------

Subject: RE: Prophet-5 Front panel LED switches

Yes.

I haven't done this on a P5 but I have repaired the Shadow switches on other
gear.



You really have to remove the whole switch from the PCB. Pop the cap (comes
off easily) and pull out the LED - however the LED leads are also the switch
leads so you have to get 'em really clean of solder to pull out easily.
Slide in a new LED and replace the cap. As I recall, the led polarity is
indicated on the switch. Resolder the switch back in to the board.



To do it without removing the switch from the PCB requires a lot of
dexterity with a very fine tip soldering iron. You cutoff the led body,
lever up the old leads and solder the new led on. There is very little room
for solder joints and the chances are you will end up with some molten
plastic :-) I've never done this on a P5 but I tried it once on another
piece of gear and gave up, going back to method 1 as quicker and easier.



Good Luck!



mw



P.S. Somebody (chipforbrains?) was selling P5 switched on eBay last week.







-----Original Message-----
From: gojko_mitic [mailto:enn.terminal@...]
Sent: Tuesday, December 02, 2003 6:25 AM
To: vintagesynthrepair@yahoogroups.com
Subject: [vintagesynthrepair] Prophet-5 Front panel LED switches



Hi,

Does anyone know whether Prophet-5 front panel LED switches can be
disassembled? I have some switches with dead LEDs, is it possible to
replace them?

Best regards,







Yahoo! Groups Sponsor



ADVERTISEMENT

<http://rd.yahoo.com/SIG=12c9eunmo/M=267637.4116730.5333196.1261774/D=egroup
web/S=1705032144:HM/EXP=1070461487/A=1853618/R=0/*http:/www.netflix.com/Defa
ult?mqso=60178338&partid=4116730> click here



<http://us.adserver.yahoo.com/l?M=267637.4116730.5333196.1261774/D=egroupmai
l/S=:HM/A=1853618/rand=581670995>


To unsubscribe from this group, send an email to:
vintagesynthrepair-unsubscribe@egroups.com



Your use of Yahoo! Groups is subject to the Yahoo!
<http://docs.yahoo.com/info/terms/>  Terms of Service.



[This message contained attachments]



________________________________________________________________________
________________________________________________________________________



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/