Xpantastic!

Hi,
It's a well built machine, removing the six screws on the ends allows you to lift the front panel of the xpander up.
The circuit board that the buttons are attached to, are actually on a special  hinge. All you have to do is remove two screws 
and the whole circuit board bends up for repair/cleaning.  From this vantage point you should be able to fix the problem.
 
 
Best
 
Karl 


On Friday, December 12, 2014 1:22 PM, "mattvrazo@... [xpantastic]" <xpantastic@yahoogroups.com> wrote:
  


  
I had the same issue on mine. Rather than opening it up, I simply took a razor blade and shaved off the edge of the button hole on the case until it didn't stick. This sounds bad, but the holes are not exactly cut in the first place, and no one is going to notice. You literally only need to shave a thin sliver, and it will still look normal.