200e

i'm not sure what you mean by the "227e mike in" if not the rear XLR jack.
that is the only input. the two 1/8" jacks on the panel are parallel
OUTPUTS.

On Mon, May 4, 2009 at 8:04 PM, amnesia <amni56@tpg.com.au> wrote:

>
>
> HI Ezra
>
> Should have the 250e back next week :-) missed it
>
> I am inputting the mic into the 227e mike in then the out env follower
> into a volt/oct...if i try and use the audio out of the mike/env into
> say channel 4 its really quiet...I havent tried the xlr on the back
>
> Ross
>
>
> ezra buchla wrote:
> >
> >
> > hm.... you used the xlr jack on the rear panel? you tried different
> > settings
> > of the pre-amp gain (the button)? anything coming out the audio output?
> >
> > 261e out -> xlr input should probably come out kinda loud and
> distorted...
> > its a lot of gain...
> >
> > On Mon, May 4, 2009 at 7:52 PM, cray5656 <amni56@tpg.com.au<amni56%40tpg.com.au>
> > <mailto:amni56%40tpg.com.au <amni56%2540tpg.com.au>>> wrote:
> >
> > >
> > >
> > > last night i tried for the first time the MIKE/ MIC in to do some env
> > > following...all i got was a really quiet signal, I thought that was
> > strange
> > > because i did the same thing with my serge and it was really
> > loud....so then
> > > i decided to put the output of the 261 into the mic in , and still
> > it was
> > > really quiet i pressed the attenuation buttons but no change.....I
> > am not
> > > sure if this is normal?
> > > I am talking the mic in on the 227e
> > >
> > > Anyone
> > >
> > > Anyone
> > >
> > > Bueler
> > >
> > >
> > >
> >
> > [Non-text portions of this message have been removed]
> >
> >
>  
>


[Non-text portions of this message have been removed]