200e

ahhh. ok i read the 1/8inch to be signal in and output...will try it 
again tonight

thanks

Ross


ezra buchla wrote:
>
>
> i'm not sure what you mean by the "227e mike in" if not the rear XLR jack.
> that is the only input. the two 1/8" jacks on the panel are parallel
> OUTPUTS.
>
> On Mon, May 4, 2009 at 8:04 PM, amnesia <amni56@tpg.com.au 
> <mailto:amni56%40tpg.com.au>> wrote:
>
> >
> >
> > HI Ezra
> >
> > Should have the 250e back next week :-) missed it
> >
> > I am inputting the mic into the 227e mike in then the out env follower
> > into a volt/oct...if i try and use the audio out of the mike/env into
> > say channel 4 its really quiet...I havent tried the xlr on the back
> >
> > Ross
> >
> >
> > ezra buchla wrote:
> > >
> > >
> > > hm.... you used the xlr jack on the rear panel? you tried different
> > > settings
> > > of the pre-amp gain (the button)? anything coming out the audio 
> output?
> > >
> > > 261e out -> xlr input should probably come out kinda loud and
> > distorted...
> > > its a lot of gain...
> > >
> > > On Mon, May 4, 2009 at 7:52 PM, cray5656 <amni56@tpg.com.au 
> <mailto:amni56%40tpg.com.au><amni56%40tpg.com.au>
> > > <mailto:amni56%40tpg.com.au <amni56%2540tpg.com.au>>> wrote:
> > >
> > > >
> > > >
> > > > last night i tried for the first time the MIKE/ MIC in to do 
> some env
> > > > following...all i got was a really quiet signal, I thought that was
> > > strange
> > > > because i did the same thing with my serge and it was really
> > > loud....so then
> > > > i decided to put the output of the 261 into the mic in , and still
> > > it was
> > > > really quiet i pressed the attenuation buttons but no change.....I
> > > am not
> > > > sure if this is normal?
> > > > I am talking the mic in on the 227e
> > > >
> > > > Anyone
> > > >
> > > > Anyone
> > > >
> > > > Bueler
> > > >
> > > >
> > > >
> > >
> > > [Non-text portions of this message have been removed]
> > >
> > >
> >
> >
>
> [Non-text portions of this message have been removed]
>
>