200e

address confusions. what is this "e-mail" ?

On Mon, May 4, 2009 at 8:12 PM, ezra buchla <ezra.buchla@gmail.com> wrote:

> oops
>
>
> On Mon, May 4, 2009 at 8:12 PM, ezra buchla <ezra.buchla@gmail.com> wrote:
>
>> i'm not sure what you mean by the "227e mike in" if not the rear XLR jack.
>> that is the only input. the two 1/8" jacks on the panel are parallel
>> OUTPUTS.
>>
>>
>> On Mon, May 4, 2009 at 8:04 PM, amnesia <amni56@tpg.com.au> wrote:
>>
>>>
>>>
>>> HI Ezra
>>>
>>> Should have the 250e back next week :-) missed it
>>>
>>> I am inputting the mic into the 227e mike in then the out env follower
>>> into a volt/oct...if i try and use the audio out of the mike/env into
>>> say channel 4 its really quiet...I havent tried the xlr on the back
>>>
>>> Ross
>>>
>>>
>>> ezra buchla wrote:
>>> >
>>> >
>>> > hm.... you used the xlr jack on the rear panel? you tried different
>>> > settings
>>> > of the pre-amp gain (the button)? anything coming out the audio output?
>>> >
>>> > 261e out -> xlr input should probably come out kinda loud and
>>> distorted...
>>> > its a lot of gain...
>>> >
>>> > On Mon, May 4, 2009 at 7:52 PM, cray5656 <amni56@tpg.com.au<amni56%40tpg.com.au>
>>> > <mailto:amni56%40tpg.com.au <amni56%2540tpg.com.au>>> wrote:
>>> >
>>> > >
>>> > >
>>> > > last night i tried for the first time the MIKE/ MIC in to do some env
>>> > > following...all i got was a really quiet signal, I thought that was
>>> > strange
>>> > > because i did the same thing with my serge and it was really
>>> > loud....so then
>>> > > i decided to put the output of the 261 into the mic in , and still
>>> > it was
>>> > > really quiet i pressed the attenuation buttons but no change.....I
>>> > am not
>>> > > sure if this is normal?
>>> > > I am talking the mic in on the 227e
>>> > >
>>> > > Anyone
>>> > >
>>> > > Anyone
>>> > >
>>> > > Bueler
>>> > >
>>> > >
>>> > >
>>> >
>>> > [Non-text portions of this message have been removed]
>>> >
>>> >
>>>  
>>>
>>
>>
>


[Non-text portions of this message have been removed]