--- In 200e@yahoogroups.com, "imabadbadkat96" <imabadbadkat96@y...>
wrote:
> Hi folks,
>
> Can someone please explain just how one updates the 200e's software?
> Is a 225e midi decoder required? I have a bare bones system at the
> moment, but I'd like to make sure I have the latest software for my
> 259e. It exhibits a couple quirks: Warp control has two very obvious
> steps at 3 and 7; both oscs show little if any change in frequency
> below 9 o'clock and above 3 o'clock.
>
> I read at buchla.com that the software is installed using a small
> card, but that's about all I know. Any help would be appreciated,
thanks.
You need a center boat from either the 201e-18 or 201e-12. The center
boat has the memory card slot. I'm not entirely sure if you need the
225e - might have to ask Buchla & Associates on this one. Maybe it
will make the FAQ. The procedure is simple: With system power off, you
insert the memory card with the new firmware in the memory slot, power
on the system while pressing the "remote enable" button on the module
you would like to update. And then you just wait until the module
returns to it's regular start-up state.
Or you can send the modules into Buchla for firmware updates.
I have done a field upgrade and I have sent my modules in.
Good luck,
E