AVR-Chat

The problem is that studio 4 doesn't  support TPI programming, but 
studio 5 does. Updating gcc is fine, but can we get a firmware upgrade 
for programming platforms like stk500 to support TPI?

Studio 5 isn't quite easy to use as 4, but eventually it worked for me. 
It appears to me like they intended studio5 to replace studio 4 and were 
going to move on.

But we have digressed from the original topic.

Did the 88 get programmed?  no,  to do ISP  use an AVR programmer with 
an ISP (6 pin) cable and header setup.  studio 4 should work fine to 
write, compile, simulate and program the 88.

rep

On 1/22/2012 7:00 PM, Jim Wagner wrote:
> Studio5 has been the subject of extended discussion on the AVRFreaks web site.
>
> It has the potential for being pretty good, but there are currently many problems. These problems do seem to be repaired over time, but it  is awfully slow and does NOT give me great confidence. This is somewhat bolstered by the apparent plan to continue updating the version of AVRgcc (to support new devices) in a way that works with Studio4.
>
> Jim Wagner
>
> On Jan 22, 2012, at 6:47 PM, Bruce wrote:
>
>> Jim,
>>
>> I am a hobbyist. Been using Studio 4. Upgraded to Studio 5. I
>> was so disappointed
>> in 5, that I decided 4 wasn't broken and went back to Studio 4.
>>
>> Any idea what the deal with AVR and Studio 5 ? I hope this is not
>> the future.
>>
>> Bruce
>>
>> On 1/21/2012 11:12 AM, Jim Wagner wrote:
>>> This is total rubbish. Studio is fine for programming. Avoid Studio5 and it works very nicely.
>>>
>>> You WILL need a programming device, such as a Dragon, but that works very well with Studio,
>>>
>>> Jim Wagner
>>> Oregon Research Electronics
>>> On Jan 21, 2012, at 1:09 AM, hamidreza maddah wrote:
>>>
>>>> Avrstudio is not good for programming. i use it for simulate
>>>>
>>>> --- On Fri, 1/20/12, sania safdar<see_wide_sea@yahoo.com>  wrote:
>>>>
>>>> From: sania safdar<see_wide_sea@yahoo.com>
>>>> Subject: [AVR-Chat] (unknown)
>>>> To: "AVR-Chat@yahoogroups.com"<AVR-Chat@yahoogroups.com>
>>>> Date: Friday, January 20, 2012, 12:35 AM
>>>>
>>>>
>>>>
>>>> kindly some one quide me about atmega88 programing in Avrstudio enviroment
>>>>
>>>>
>>>>
>>>> Best Regards
>>>>
>>>> Sania Safdar
>>>>
>>>> [Non-text portions of this message have been removed]
>>>>
>>>> [Non-text portions of this message have been removed]
>>>>
>>>>
>>>
>>> [Non-text portions of this message have been removed]
>>>
>>>
>>>
>>> ------------------------------------
>>>
>>> Yahoo! Groups Links
>>>
>>>
>>>
>>>
>> [Non-text portions of this message have been removed]
>>
>>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>