Boss VF-1 Effect Processor

Since there are 4 controller assignments, make sure only 1 is On and the other 3 are Off.  This is the only way to make sure you're isolating one particular case.

While on the single active controller assignment, which you've obviously set to Expression Pedal source, try selecting different destinations and you should hear ONLY the selected destination parameter being modulated.

Ryan

--- In BossVF1@yahoogroups.com, Dustin Sedlacek <dustin.sedlacek@...> wrote:
>
> Ok I did find the master settings it is one of those things that I was
> somehow over looking. Now my issue is that I cannot get it to act in a
> predictable way. It just keeps turning the algorithm block on and off  even
> though I have set it for pitchshifter - pitch.
> 
> 
> Again, I am feeding it with a hot audio signal so I expect it to be erratic,
> but not unpredictable.
> 
> 
> 
> On Sat, Jul 23, 2011 at 9:10 PM, Ryan <rwrubleski@...> wrote:
> 
> > **
> >
> >
> > Hi Dustin,
> >
> > I'm tempted to say RTFM, but since this board doesn't get any action, I'll
> > bite:
> >
> > The expression pedal can be used in any of the 4 Master settings'
> > Controller Assignments. Go the Master settings, and scroll over to the
> > controller assignments and explore. There are 4 of them. Your source can be
> > a control pedal (latch or momentary), expression pedal, or MIDI CC. Your
> > target can be just about ANY parameter that pertains to the algorithm you're
> > on. For the expression pedal, you can set the applicable range of the pedal,
> > and the corresponding range of the parameter values it will sweep through.
> >
> > Therefore, you can use an expression pedal to modulate just about any
> > parameter however you wish. Use your imagination! Wah pedal? Of course!
> > Volume pedal? Natch! Modulate the amount of reverb, amount of distortion,
> > delay repeats, etc. etc. etc.! The possibilities are vast!
> >
> > You can also use it to turn all the effects on or off (as you witnessed),
> > or individual effects on and off. The possibilities are amazing, and I
> > encourage you to get a real expression pedal and go nuts!
> >
> > Ryan
> >
> > --- In BossVF1@yahoogroups.com, "Dustin ." <dustin.sedlacek@> wrote:
> > >
> > > I am running an audio signal into the expression inputs on my VF1 I didnt
> > expect much results but I am getting results....the effects turn on and off.
> > Is it possible to get this signal to other things?
> > >
> >
> >  
> >
> 
> 
> 
> -- 
> Dustin Sedlacek
> 901-828-6801
> 
> 
> [Non-text portions of this message have been removed]
>