Casio CZ/ VZ/ FZ - Pro Series

Unless I hear that you already know the answer, I'll open mine up 
tomorrow morning (it's midnight here in Germany). I'm assuming that 
if all cables are attached, that's all you need to know? I've opened 
it a lot recently, so it's no big deal :o)

Just hang on for 12 hours or so...

Cheers
Fritzi

--- In CZsynth@yahoogroups.com, josephex@j... wrote:
> To the Casio Keyboards yahoo group, I'm new.  I'm e-mailing both 
that group and the 
> CZsynth group right now about this issue.
> 
> I'm still looking for schematics of the CZ 101.  Those of you on 
the CZsynth group 
> may remember I'm looking for them.
> 
> If I can't get them, is there someone here brave enough to open 
their CZ 101 up and 
> check something for me?  There are two ribbon cables near the 
cartridge area.  I just 
> want to find out if both are connected to a board on both ends, or 
if one of them is 
> supposed to be disconnected on one end.
> 
> Opening this synth up isn't as scary as it may sound.  Then again, 
I normally kind of 
> know what I'm doing when I open up electronic stuff anyway.
> 
> I'm asking because one of mine is disconnected on one end and if 
it's supposed to 
> be connected, I think I may have found a problem (if not the 
problem) with my synth.
> 
> The casiokeyboard grouip is not yet familiar with my problem.  I 
cannot access tones 
> 9 - 16 by hitting the select key.  It locks up when I try.  It 
goes into tone mix mode and 
> gets stuck.  I can access those banks when I choose to go into 
tone mix mode 
> though, so I know those tones are still there.
> 
> JoeyJoey Cagle AKA Joseph Experimental
> 501 Will Rd.
> Middlesex, NC 27557
> 
> http://www.josephexperimental.com - The Other Electronic Music.
> (919) 269 7969