Casio CZ/ VZ/ FZ - Pro Series

> thought it might be possible to cram into a 3u or 4u unit.  One of my main
> worries was drilling the front-panel.  I have access to a decent bench drill
> but I know nothing of 'square' hole drilling- you suggest re building the
==================================

there are 2 ways to cut square holes.....

the cheaper way is t get a "nibler" tool ($10) and do it by hand....
you have to be careful, it's fairly easy to screw-up.

the better way ($50+) is a "punch". the cheaper punches (under $200) are 2
peices of hardened steel, that clamp through a pilot hole, and you tighten
a screw, "punching" out whatever is between the 2 halves. punches are made
for round, square, db25, etc shaped holes.

the nibler is good on most material up to 3/16inch think.

the punch is good for thicker stuff, depending on the material.

        ...atom

----------------Void-If-Detached----------------
http://smasher.suspicious.org/fs1r  Yamaha FS1R

	"What sane person could live in this world and not be crazy?"
		-- Ursula K. LeGuin