Yahoo Groups archive
Thread
2012-07-18 by noisepenguin
Hello, I have an old CZ1000 that I would like to reset to the factory presets. Right now the sounds are not all correct, some patches are but some patches are wonky. How would you do this? Thanks
2012-07-19 by Lee Borrell
To my knowledge - insert a pen/pencil/sharp object into the P button on the base of the unit when powering on - this will return it to basic settings. ________________________________
From: noisepenguin <noisepenguin@yahoo.com> To: CZsynth@yahoogroups.com Sent: Wednesday, 18 July 2012, 16:11 Subject: [CZsynth] Old CZ1000, factory patches help Hello, I have an old CZ1000 that I would like to reset to the factory presets. Right now the sounds are not all correct, some patches are but some patches are wonky. How would you do this? Thanks [Non-text portions of this message have been removed]
2012-07-19 by noisepenguin
I posted this at work and now I realize my synth is a CZ-1!!! How would I restore one of these to the factory presets? --- In CZsynth@yahoogroups.com, Lee Borrell <templarser@...> wrote:
> > To my knowledge - insert a pen/pencil/sharp object into the P button on the base of the unit when powering on - this will return it to basic settings. > > > > ________________________________ > From: noisepenguin <noisepenguin@...> > To: CZsynth@yahoogroups.com > Sent: Wednesday, 18 July 2012, 16:11 > Subject: [CZsynth] Old CZ1000, factory patches help > > > Â > Hello, I have an old CZ1000 that I would like to reset to the factory presets. Right now the sounds are not all correct, some patches are but some patches are wonky. How would you do this? > Thanks > > > > > [Non-text portions of this message have been removed] >
2012-07-20 by bill bigrig
Push the P button AFTER power up. Rig [Non-text portions of this message have been removed]
2012-07-22 by narfman96
The factory presets are always available in the CZ-1. Hold down the Initialize button and select a patch using the bank and patch number buttons. Ex. A1 through H8. The Compare/Recall key will then allow you to switch back and forth between the Internal patch and the Preset patch. To save each of the Preset patches use the write procedure and make sure the Write Protect switch is off on the back panel. The initialize procedure is detailed on page 14 in the CZ-1 manual. --- In CZsynth@yahoogroups.com, "noisepenguin" <noisepenguin@...> wrote:
> > I posted this at work and now I realize my synth is a CZ-1!!! How would I restore one of these to the factory presets? > > --- In CZsynth@yahoogroups.com, Lee Borrell <templarser@> wrote: > > > > To my knowledge - insert a pen/pencil/sharp object into the P button on the base of the unit when powering on - this will return it to basic settings. > > > > > > > > ________________________________ > > From: noisepenguin <noisepenguin@> > > To: CZsynth@yahoogroups.com > > Sent: Wednesday, 18 July 2012, 16:11 > > Subject: [CZsynth] Old CZ1000, factory patches help > > > > > > Â > > Hello, I have an old CZ1000 that I would like to reset to the factory presets. Right now the sounds are not all correct, some patches are but some patches are wonky. How would you do this? > > Thanks > > > > > > > > > > [Non-text portions of this message have been removed] > > >