Dave Smith Instruments SYNTHESIZERS

My sincere apologies, Simon, I misunderstood.

Yes, you're right.  If you set a sequencer destination to Clock Mod 
(even if just "running over it") while running the sequencer, it WILL 
change the tempo of the sequence to something other than the BPM 
setting, unless all sequencer steps are set to 40.  That's what it's 
supposed to do though, of course.  It changes the tempo, and the 
tempo won't change back until you DO something to change the tempo.  
I find it easiest to change the tempo back by tweaking the BPM 
setting by a notch and then back again.  Maybe Dave could program the 
Reset to do this, too.


Ski
www.ex5tech.com
EX5Tech Evolver forum:
http://www.ex5tech.com/ex5ubb_cgi/ultimatebb.cgi?ubb=forum&f=23


--- In DSI_Evolver@yahoogroups.com, simon leclerc <Simonvolt@v...> 
wrote:
> 1.6 does not resolve what i'm describing below.
> diS / CLO are now seperated, but if run over
> CLO it changes all clock settings and the only way
> to get it back is to manually put all steps
> to 40 or do a program reset.
> 
> 
> on 29/09/03 11:54 PM, ski_ex5tech at ex5tech@e... wrote:
> 
> As already posted to the group and to EX5Tech, OS beta 1.6 solves
> this problem.  Check the posts from the past couple days, or go
> download beta 1.6 for yourself to give it a try.
> 
> 
> Ski
> www.ex5tech.com
> EX5Tech Evolver forum:
> http://www.ex5tech.com/ex5ubb_cgi/ultimatebb.cgi?ubb=forum&f=23
> 
> --- In DSI_Evolver@yahoogroups.com, "Simon " <Simonvolt@v...> wrote:
> > Just a note: 
> > I think  modulating the clock is great (diS is great too :))
> > but like i mentionned in OS 1.5, everytime you run over the
> > CLO destination, your original clock settings get screwed.  You
> > either have to manually set all steps to 40 or start over and 
reset
> > the program.
> > Would it be possible to get back to the previous clock settings
> > when leaving CLO ?
> > Cause you'll see that it can be really anoying to reach for diS 
but
> > accidentally run over CLO and scew up your program.
> > 
> > Simon
> 
> 
> Yahoo! Groups Sponsor   ADVERTISEMENT
>  
> To unsubscribe from this group, send an email to:
> DSI_Evolver-unsubscribe@yahoogroups.com
> 
> 
> 
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service
> <http://docs.yahoo.com/info/terms/> .