Dave Smith Instruments SYNTHESIZERS

The Evolver only has about 6 general CC's that you can use..(that I can
remember). 

The ones I know of :

Velocity
Breath Control
Pressure
Foot Control
Mod Wheel


I looked through the manual to see what CC's these are assigned to on the
Evolver, but I didn't see it.  I'm pretty sure Velocity is CC 2.  You would
then assign one of the knobs on the Modular to send midi CC 2 via it's
software.  Then tell the Evolver that you want Velocity to control LFO 1
freq, or whatever you want.  But again, I don't know what the other 5 or so
CC's are on the evolver.  Given that, you'll only be able to control 5 or 6
parameters at once w/o sending sysex.  If you want to do that, then you'll
have to purchase a controler on which you can program sysex messaging.

> -----Original Message-----
> From: roid64 [mailto:cappamorestudio@...] 
> Sent: Sunday, January 30, 2005 12:46 PM
> To: DSI_Evolver@yahoogroups.com
> Subject: [Evolver] Controllers for the EVO
> 
> 
> 
> Hi I'm new to the board so pardon my ignorance!! OK, what I 
> want to do is this; I've set up a patch similar to a VCS3 to 
> make synthi- bubble type noises like Tim Blake/Ozrics. For 
> ultimate tweakability I need to be able to access all the 
> parameters of the 4 lfos without using the shift button. I 
> was hoping to use a controller for this. I have set a patch 
> up in my Nord Modular to act as the controller, i know the 
> Evo gets the midi info cos the status led lights up, but I 
> don't know how to assign the relevant parameters to the 
> relevant knobs on the Nord, any ideas? 
> 
> 
> 
> 
> 
> ------------------------ Yahoo! Groups Sponsor 
> --------------------~--> Has someone you know been affected 
> by illness or disease?
> Network for Good is THE place to support health awareness efforts!
> http://us.click.yahoo.com/pKxVKC/UOnJAA/n1hLAA/QnLolB/TM
> --------------------------------------------------------------
> ------~-> 
> 
>  
> Yahoo! Groups Links
> 
> 
> 
>  
> 
> 
>