Dave Smith Instruments SYNTHESIZERS

Where did you get the new encoders from?

Bob
El Segundo, CA


-----Original Message-----
>From: Bernie <kornowicz@...>
>Sent: Nov 4, 2008 8:05 AM
>To: DSI_Evolver@yahoogroups.com
>Subject: [DSI Synths] Re: PEK Wiggly rotory encoders
>
>--- In DSI_Evolver@yahoogroups.com, "synthmdl76" <synthmdl76@...> wrote:
>>
>> I have a few encoders that seem a bit wiggly compared to the others. 
>> It is not loose knobs but the actual axle shaft where is goes into the
>> encoders metal housing.  It still works fine but just wounding if its
>> normal.
>> 
>> and just to mention i have very little use on the PEK
>>
>
>I had several of my PEK encoders replaced recently. The new ones are 
>much better than the old ones; nice and snug.
>
>Bernie
>