Dave Smith Instruments SYNTHESIZERS

I sent my boards to DSI. I tried replacing the original encoders 
with some that I got from DSI, but my soldering skills leave much to 
be desired.

Bernie

--- In DSI_Evolver@yahoogroups.com, "Bob S." <tttsystems@...> wrote:
>
> Where did you get the new encoders from?
> 
> Bob
> El Segundo, CA
> 
> 
> -----Original Message-----
> >From: Bernie <kornowicz@...>
> >Sent: Nov 4, 2008 8:05 AM
> >To: DSI_Evolver@yahoogroups.com
> >Subject: [DSI Synths] Re: PEK Wiggly rotory encoders
> >
> >--- In DSI_Evolver@yahoogroups.com, "synthmdl76" <synthmdl76@> 
wrote:
> >>
> >> I have a few encoders that seem a bit wiggly compared to the 
others. 
> >> It is not loose knobs but the actual axle shaft where is goes 
into the
> >> encoders metal housing.  It still works fine but just wounding 
if its
> >> normal.
> >> 
> >> and just to mention i have very little use on the PEK
> >>
> >
> >I had several of my PEK encoders replaced recently. The new ones 
are 
> >much better than the old ones; nice and snug.
> >
> >Bernie
> >
>