Dave Smith Instruments SYNTHESIZERS

I have a few encoders that seem a bit wiggly compared to the others. 
It is not loose knobs but the actual axle shaft where is goes into the
encoders metal housing.  It still works fine but just wounding if its
normal.

and just to mention i have very little use on the PEK

--- In DSI_Evolver@yahoogroups.com, "synthmdl76" <synthmdl76@...> wrote:
>
> I have a few encoders that seem a bit wiggly compared to the others. 
> It is not loose knobs but the actual axle shaft where is goes into the
> encoders metal housing.  It still works fine but just wounding if its
> normal.
> 
> and just to mention i have very little use on the PEK
>

I had several of my PEK encoders replaced recently. The new ones are 
much better than the old ones; nice and snug.

Bernie

Where did you get the new encoders from?

Bob
El Segundo, CA


-----Original Message-----

>From: Bernie <kornowicz@...>
>Sent: Nov 4, 2008 8:05 AM
>To: DSI_Evolver@yahoogroups.com
>Subject: [DSI Synths] Re: PEK Wiggly rotory encoders
>
>--- In DSI_Evolver@yahoogroups.com, "synthmdl76" <synthmdl76@...> wrote:
>>
>> I have a few encoders that seem a bit wiggly compared to the others. 
>> It is not loose knobs but the actual axle shaft where is goes into the
>> encoders metal housing.  It still works fine but just wounding if its
>> normal.
>> 
>> and just to mention i have very little use on the PEK
>>
>
>I had several of my PEK encoders replaced recently. The new ones are 
>much better than the old ones; nice and snug.
>
>Bernie
>

I sent my boards to DSI. I tried replacing the original encoders 
with some that I got from DSI, but my soldering skills leave much to 
be desired.

Bernie

--- In DSI_Evolver@yahoogroups.com, "Bob S." <tttsystems@...> wrote:
>
> Where did you get the new encoders from?
> 
> Bob
> El Segundo, CA
> 
> 
> -----Original Message-----
> >From: Bernie <kornowicz@...>
> >Sent: Nov 4, 2008 8:05 AM
> >To: DSI_Evolver@yahoogroups.com
> >Subject: [DSI Synths] Re: PEK Wiggly rotory encoders
> >
> >--- In DSI_Evolver@yahoogroups.com, "synthmdl76" <synthmdl76@> 
wrote:
> >>
> >> I have a few encoders that seem a bit wiggly compared to the 
others. 
> >> It is not loose knobs but the actual axle shaft where is goes 
into the
> >> encoders metal housing.  It still works fine but just wounding 
if its
> >> normal.
> >> 
> >> and just to mention i have very little use on the PEK
> >>
> >
> >I had several of my PEK encoders replaced recently. The new ones 
are 

> >much better than the old ones; nice and snug.
> >
> >Bernie
> >
>