Digital BW, The Print

Glenn:

Might be a problem with the F-16, the cart chips, or your printer.  
If you have Epson carts that you haven't run dry, you might try re-
installing them to see if you can get a printer reset to eliminate 
your printer as a source of the problem.  Remember to plug the outlet 
holes of your CFS carts if you remove them even for just a little 
while.  Make sure to turn the power off when removing and installing 
the carts (some folks also unplug the power cable).  

Jeff Randall

--- In DigitalBlackandWhiteThePrint@y..., "Glenn Thureson" 
<glennthureson@a...> wrote:
> I have the VM ink all set up and looking good.  However, when I 
turned on
> the
> printer (1280), the ink light was on.  So I went through all of the 
F-16
> procedure (as far as I can tell), but to no avail.
> 
> I have gotten successfully through step 3c in the F-16 
instructions.  Step
> 3d fails, 1280 ink light still on.  Then I went to Note 1 on page 
5.  Still
> no joy.  The ink light remains on.
> 
> And MIS is moving.
> 
> I would appreciate your help.
> 
> Glenn Thureson