Digital BW, The Print

Jerry,

I can't push the color cart in as far as the black one -- when I try to push
it down farther, it flexes the whole cart hold (and, I presume, the heads).
I'm using the Modified Cartridge Clamps, and the color clamp is a doozy to
close.  Should I have removed the felt pads?

Glenn

----- Original Message -----
From: "Jerry Olson" <jerryolson@...>
To: <DigitalBlackandWhiteThePrint@yahoogroups.com>
Sent: Thursday, October 03, 2002 3:18 PM
Subject: Re: [Digital BW] F-16 failure -- new CFS


> Are the cartridges down far enough to trip the little switch?  Try
> pulling them up and reseating them. That's almost surely what the
> problem is.
>
> Glenn Thureson wrote:
> >
> > I have the VM ink all set up and looking good.  However, when I turned
on
> > the
> > printer (1280), the ink light was on.  So I went through all of the F-16
> > procedure (as far as I can tell), but to no avail.
> >
> > I have gotten successfully through step 3c in the F-16 instructions.
Step
> > 3d fails, 1280 ink light still on.  Then I went to Note 1 on page 5.
Still
> > no joy.  The ink light remains on.
> >
> > And MIS is moving.
> >
> > I would appreciate your help.
> >
> > Glenn Thureson