Digital BW, The Print

Did that fix it for you? The thin-lines/microbanding just came back
last night on my 1270.. wasted 2 13x19 prints already. 

Slightly over-filled carts? That's strange. My old cart is close to
finish when that happened last night so I replaced it with a new one.
And it is still there. I switched with a OEM 007 cart and it's working
fine. But once switched back to the new UT2 black cart it's back. (And
I did cleaning cycles and purge prints).

Anyway, I gave up last night and did a tiny test print this morning
before heading to work. It seems to be working ok again.. (But then it
could work fine for half a 13x19 and the 2nd half is bad).

I am getting quite sick of the problems. Would a UT2 CIS work better
or worse? Or should I just dump the setup to get a 2200 and stay with
Epson ink and print with QTR or BlackOnly.. 

Michael

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "jturner4210626"
<JTurner421@a...> wrote:
> 
> Quick follow up.  I e-mailed tech support at MIS and this was their 
> reply:
> 
> 
> This problem can be caused by a slightly over filled cartridge. It 
> does not pose a problem and can usually be cleared by running three 
> cleaning cycles. You may repeat the process if necessary and you may 
> also print our purgeblack page to prevent the system from trying to 
> spray extra ink. 
>  
> It wiill clear up by the time you have finished these steps. 
>  
> You down load our purge files at this link....
> http://www.inksupply.info/?_a=downloads