Digital BW, The Print

I'll take a look at it if you want. You can email me at the following:

greg <AT> dfaprinting <DOT> com (Yahoo always hides the email address, 
so you'll have to put it together). I'm up in central NY so at least in 
the same country.

I might at least be able to copy the wires from my 9500 To figure out 
which goes where. If you order the motor, I would expect it to come 
with a new connector on the end of the wire. As far as the connector 
for the board, that might be difficult to obtain from an Epson parts 
place. It could be easy to salvage off of something like and old video 
tape machine (which I have plenty of at my regular job). The big 
question is what condition the board is in. That might be a little 
harder to fix. Often with the multi layer boards, component leads are 
used to help bridge connections from one layer to the next. If any of 
those get broken, putting all the connections back together can be a 
real pain (but not impossible).

I never did check to make sure I have a manual for the 7000, so I 
prolly better do that.