Digital BW, The Print

I¹m not sure if this has been resolved yet. I too have started my first few
prints of B&W on the epson 2400...

I can only select VFA when manual roll is selected in page setup, otherwise
it is grayed out. If I save the config. and go back to switch to the regular
top load, all my saved settings revert back to default on the print menu...



On 10/14/06 10:06 AM, "Clayton Jones" <cj@...> wrote:

>  
>  
>  
> 
> Hello Mike,
> 
>> >...until I selected "manual-roll" under page setup and used the
>> >single sheet feeder on the back.
> 
> Ahh, of course.  I had a feeling I was forgetting something.  Once you
> have it selected it should remain available.  It also should be
> possible to switch it back to sheet feeder (it may pop up a warning
> but it can be ignored - I run VFA through the sheet feeder all the time).
> 
>> >Interestingly, I got slightly better results on the particular image
>> >I was working on with watercolor radiant on Kayenta.
> 
> Good tip.  I'll give that a try next time I use Kayenta.
> 
> Regards,
> Clayton
> 
> Info on black and white digital printing at
> http://www.cjcom.net/digiprnarts.htm
> 
>  
>     


-- 




[Non-text portions of this message have been removed]