Digital BW, The Print

Eric, I don't think anything has been done on this printer as far as 
maintenance goes.  I believe it was used very little.  Maybe it is 
time for the dampers and wiper to be changed.

Thanks,
Jenny

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Eric Neilsen" 
<e.neilsen2@...> wrote:
>
> You may want to do an advanced head alignment. It uses up about 12 
ft of
> paper but will help detect deflected nozzles and alignment issues 
that might
> otherwise not be seen in the other set ups that are typically 
performed.
> When was the last time the wiper was changed?  Last time I saw that 
was just
> before a dampers and wiper replacement. 
> 
>  
> To: DigitalBlackandWhiteThePrint@yahoogroups.com
> Subject: [Digital BW] 7000/K6
> 
>  
> 
> Printing a step wedge 
> using QTR (better/ordered) reveals a nice ramp but there's very 
fine 
> banding around 15-35% which disappears until 55-75% then it 
disappears 
> again. And the 100% block has pronounced banding (fine white 
lines). 
> Oh, and the text is slightly blurred with stray tiny black dots. 
Other 
> than those problems, it's a nice ramp! :)
> 
>> 
> Thanks!!!
> 
> Jenny Ellerbe
> 
>  
> 
> 
> 
> [Non-text portions of this message have been removed]
>