MIS FSe + Epson 2000P = Success !
2002-09-10 by B. Alex Pettit Jr.
I am most happy with the results I have obtained with the first few 8x10s printed this morning. I printed the Piezo test chart on EAM, scanned it with an old HP 4C and sampled the density steps after a Gaussian blurr to blend the paper texture variance. The curve is smooth and correct within a few percent. I am still using the black Epson ink, and there is a small drop in density at the 80% point and above, but other than that, it is just seems fine without any correction curves. I did swap the Y and PMe inks as I felt the yellow ink was too dark. I had fully intended to mothball this 2KP in the closet and purchase a 1280. I am impressed with these results.... Alex