There is not much to know though.
Plug something into the audio input (and turn the level up) and then take the output from one of the jacks on the right side.
A is All Pass
H is High Pass
B is Band Pass
N is Notch
L is Low Pass
The number is the number of poles
4 = 4 pole = 24db/octave
2 = 2 poles = 12db/octave
FCV1 is control voltage that controls the Cutoff frequency. Patch in the output of an envelope generator or any other control voltage source.
FCV2 also controls the cutoff frequency but has the attenuator knob beside it so you can control how much.
QCV controls the resonance (Q, emphasis)
and the switch at the bottom just toggles between filter types on each of the output jacks eg: the bottom jack is either 1 pole low pass or if the switch is to the right it's 2pole low pass.
That's about it. Go crazy.
Scott
At 01:20 PM 5/11/2015, you wrote:
I have the a100 Manuel and noticed the a106-6 didn't have a pdf.. New to this so just wanted a few patch ideas to get me going like most of the other doepfer PDFs have.. Is there a pdf for another filter which you can recommend looking at at ? Cheers jase
Sent from my iPhone
On 11 May 2015, at 13:32, Neil Kagan blinkenlicht@yahoo.com [Doepfer_a100] < Doepfer_a100@yahoogroups.com> wrote:
It doesn't work any differently to the others, the manual lists the filter types if that's what you need?
Neil
Sent from my iPhone
On 11 May 2015, at 09:47, sachavaughan@yahoo.com [Doepfer_a100] < Doepfer_a100@yahoogroups.com> wrote:
Hi, don't suppose anyone has any patch examples or ideas on how to use the titled filter do they?
Cheers Jase