QTR-Quadtone RIP

Richard, 


Thank you so much for clearing this up. I didn't check the lower box which is 
what confused me since I still got the embedded sRGB profile. I checked the 
top box- Leave as Is. I suspected the issue was either Adobe or El Capitan 
(I'm not a fan). However, the tutorial I was using said Untagged must be shown 
in the embedded box. I did try once with CS5 instead of CS6- same result. Now 
that I know it doesn't matter as long as No Color Management is selected in 
Print Tool I will go ahead with my linearization. Thanks again. You saved me a 
lot of time and research. 


Cheers, 


Charlie
Sent with [inky](http://inky.com?kme=signature)
"richard@... [QuadtoneRIP]" <QuadtoneRIP@yahoogroups.com> 
wrote: 


> I'm sorry, but I haven't had coffee yet when I read your post. You are using 
> print tool.... 
>  
>  
> I think there was some point that when you saved the ink step image in 
> Photoshop the box that says save with srgb was checked (your working space?) 
> just open it back in Photoshop, make your changes to the ink sep image and 
> then when you save as... Make sure you don't have the check box with "embed 
> color profile" at the bottom of save dialog box checked. 
>  
>  
> In any case printing in print tool with no color management should ignore 
> whatever embedded color profile embedded is in there and should print fine. 
> (Haven't tested that is a while yet though...) 
>  
>  
> Sorry about the confusion in my last message. 
>  
>  
> Richard Boutwell 
>
>  
>