QTR-Quadtone RIP

I use 1.4.10 and a 3800 connected with ethernet.  I found the easiest way is to
use Apple's "no setup" protocol called Bonjour or Rendevous.  You'll have to see
if this works with 10.3.9 and a 4800.  See the Tutorial.pdf on the
last couple of
pages.  The description is for the Airport USB port but the same idea should
work for the ethernet connection.

Roy

On 9/10/07, mberman89 <j6mb@...> wrote:
> I down loaded 2.4.1 about a year ago
>
> I had difficulty with the install  ... and a lot of work so I let it
> sit.  I am trying once again to see if I can get it to work.
>
> I figured out the install   ...  but I can not get it to find the
> printer.
>
> Everything showed up on "print with preview" correctly, "page set up"
> was correct ... and on "print" quad rip shows up .. I set the two
> curves, set the printer ... press print. And it does not find the
> printer. I did a reinstall  ...  still can not find the printer. The
> Quad4800 icon shows up in the tool bar computer starts to cycle the
> print, but there is no response from the printer and then the icon
> disappears.
>
> I am using a Mac OS X  10.3.9 with an epson 4800 ...  Epson K3 ink...
> I have it hooked up to the computer with an ethernet cable.
>
> If I change the printer setting in "print" from Quad4800 to
> StylusPro4800-B9249F  it works with all the same settings  ...  ugly
> print but it can find the printer.
>
> Any suggestions  ... I am dyslexic so I sometimes have problems with
> all the names for things on a computer program and instructions.
>
> The only thing I can figure is I do not have the correct address  .. I
> am using IP address from Systems Preferences - Network - Built in
> Ethernet : TCP/ IP : IP Address.  Is there away to find out what the
> ethernet setting is for StylusPro4800-B9249F.
>
> any other ideas?
>
> thanks