QTR-Quadtone RIP

roy

I have just been slammed with a few deadlines  ... and then I am off
for a few weeks to photograph  .. not sure if I understand all this in
the email  ... but when I return I will give it some attention.

thanks

michael berman


--- In QuadtoneRIP@yahoogroups.com, "Roy Harrington" <roy@...> wrote:
>
> I use 1.4.10 and a 3800 connected with ethernet.  I found the
easiest way is to
> use Apple's "no setup" protocol called Bonjour or Rendevous.  You'll
have to see
> if this works with 10.3.9 and a 4800.  See the Tutorial.pdf on the
> last couple of
> pages.  The description is for the Airport USB port but the same
idea should
> work for the ethernet connection.
> 
> Roy
> 
> On 9/10/07, mberman89 <j6mb@...> wrote:
> > I down loaded 2.4.1 about a year ago
> >
> > I had difficulty with the install  ... and a lot of work so I let it
> > sit.  I am trying once again to see if I can get it to work.
> >
> > I figured out the install   ...  but I can not get it to find the
> > printer.
> >
> > Everything showed up on "print with preview" correctly, "page set up"
> > was correct ... and on "print" quad rip shows up .. I set the two
> > curves, set the printer ... press print. And it does not find the
> > printer. I did a reinstall  ...  still can not find the printer. The
> > Quad4800 icon shows up in the tool bar computer starts to cycle the
> > print, but there is no response from the printer and then the icon
> > disappears.
> >
> > I am using a Mac OS X  10.3.9 with an epson 4800 ...  Epson K3 ink...
> > I have it hooked up to the computer with an ethernet cable.
> >
> > If I change the printer setting in "print" from Quad4800 to
> > StylusPro4800-B9249F  it works with all the same settings  ...  ugly
> > print but it can find the printer.
> >
> > Any suggestions  ... I am dyslexic so I sometimes have problems with
> > all the names for things on a computer program and instructions.
> >
> > The only thing I can figure is I do not have the correct address  .. I
> > am using IP address from Systems Preferences - Network - Built in
> > Ethernet : TCP/ IP : IP Address.  Is there away to find out what the
> > ethernet setting is for StylusPro4800-B9249F.
> >
> > any other ideas?
> >
> > thanks
>