QTR-Quadtone RIP

I'm unable to print the inkseperation6.tif file through CS3.  I have a printer QuadR200 
installed.  The printer is online and functioning for nozzle checks and through the epson 
driver.

I open the inkseperation6.tif file in CS3.  Check that in page setup that QuadR200 is selected 
as well as on the next page.  I have no color management checked.  I select Quadtone rip and 
select calibration mode.  The calibration ink level is set to the middle as I can't remember if it 
should be at 0 or 100 at this point then hit print.  The printing page 1 page comes up.  
Opening the QuadR200 printer box shows the "printing percentages" climbing and then 
nothing.  I get the message "no jobs to print"  Where to go next?

--- In QuadtoneRIP@yahoogroups.com, "robert49brake" <robert49brake@...> wrote:
>
> I'm unable to print the inkseperation6.tif file through CS3.  I have a printer QuadR200 
> installed.  The printer is online and functioning for nozzle checks and through the epson 
> driver.
> 
> I open the inkseperation6.tif file in CS3.  Check that in page setup that QuadR200 is 
selected 
> as well as on the next page.  I have no color management checked.  I select Quadtone rip 
and 
> select calibration mode.  The calibration ink level is set to the middle as I can't remember if 
it 
> should be at 0 or 100 at this point then hit print.  The printing page 1 page comes up.  
> Opening the QuadR200 printer box shows the "printing percentages" climbing and then 
> nothing.  I get the message "no jobs to print"  Where to go next?

forgot to add that I have modified a nuetral curve, changed to calibration=yes, Changed ink 
limits to 0, saved under another name, installed that curve, etc.
>

Why are you printing through CS3?  Why not print through QTR?

On 7/10/07, robert49brake <robert49brake@...> wrote:
>
> I'm unable to print the inkseperation6.tif file through CS3.  I have a
> printer QuadR200
> installed.  The printer is online and functioning for nozzle checks and
> through the epson
> driver.
>
> I open the inkseperation6.tif file in CS3.  Check that in page setup that
> QuadR200 is selected
> as well as on the next page.  I have no color management checked.  I
> select Quadtone rip and
> select calibration mode.  The calibration ink level is set to the middle
> as I can't remember if it
> should be at 0 or 100 at this point then hit print.  The printing page 1
> page comes up.
> Opening the QuadR200 printer box shows the "printing percentages" climbing
> and then
> nothing.  I get the message "no jobs to print"  Where to go next?
>


[Non-text portions of this message have been removed]