The Cyndustries List

That (grounding) was my main original concern. Can someone confirm this one way or another? 

If the case is yes can I do that via the sixpaks or should I wire the grounds of the two power supplies directly?



thanks!





--- In The_Cyndustries_List@yahoogroups.com, Chris Muir <cbm@...> wrote:

> Shouldn't there be something about connecting the grounds on the old  
> and the new supply in this list?
> 
> 
> On Jun 10, 2009, at 7:25 AM, stevemodularland wrote:
> > #1 Test it to make sure it makes a clean + and - 15V
> >
> > #2 Make a cable to connect it properly to the distro card
> >
> > #3 Test the distro card to double check that voltages are correct
> >
> > #4 Plug in your modules
> >
> > #5 Make a drink based with clear rum
> >
> > Do NOT "add" power in "parallel" with the other power supply. Power  
> > supplies aren't passive lead-acid batteries.
> >
> > --- In The_Cyndustries_List@yahoogroups.com, "legionhwp"  
> > <legionhwp@> wrote:
> > >
> > > I've maxed out my large Cyndustries PS and have a 2nd +/- Motm PS  
> > I've wired into my empty six pak. Whenever I've used any other synth  
> > (serge, fenix, etc I always used the green ground out on the Cyn PS.  
> > What do I need to do to intergrate the new MOTM ps with my existing  
> > Cyn/Modcan system?
> > >
> > > I have combo/distro cards in all my Sixpaks so I could wire them  
> > in series if needed to.
> > >
> > > Any suggestions appreciated.
> > >
> > > D_
> > >
> >
> >
> > 
> 
> Chris Muir
> cbm@...	
> http://www.xfade.com
>