Akai S1000 / S1100 samplers

Hi,

Thanks for the jumper info. But, how do I connect the drives? Only 
one connector is available on the SCSI cable, the other connector is 
joined on the SCSI card by soldering. Are there any SCSI adapters or 
cables out there extending the number of connectors? Is it possible 
to integrate 68 pins cables, 50-to-68-pins adapters and so on?

If I manage to collect a service manual, I'll let you know!

Thanks.


Regards,

Mattias

--- In akaiS1000S1100Samplers@yahoogroups.com, "formals777" 
<frank.govaerts@p...> wrote:
> Hi,
> 
> For connecting the internal scsi cable, there is not much you can do
> wrong because the internal HD and the ZIP define their ID's through
> the jumpers you will find on them. You know this works with a binary
> system. Normally there are three jumpers: ID0, ID1 and ID2. Just 
make
> sure that they have a different id. 
> The scsi cable should have a white mark on one side. That must be
> aligned with pin 1 on the scsi connectors. 
> 
> I have never seen a service manual. 
> 
> Which other cables must be connected? Normally only the power supply
> cables. Let us know. Someone on the list can supply you with some
> pictures. 
> 
> Rgds
> 
> Frank 
> 
> 
> --- In akaiS1000S1100Samplers@yahoogroups.com, "koppeti"
> <mathias_cedergren@h...> wrote:
> > Hi all,
> > 
> > First, I would like to say that this is a very nice community.
> > 
> > Now to my problems ... I recently decided to upgrade the 
internal, 
> > enormous 40MB hard drive of my S1000HD. At the same time I also 
> > replaced the backlight panel and replaced the floppy drive with a 
Zip 
> > 100MB drive. So far, so good ... Now, I would like to reconnect 
all 
> > those disconnected cables (the way I labeled the cables turned 
out to 
> > be quite unsuccessful).
> > 
> > Does anyone know where I can find some service documentation or 
> > schematics for the S1000? Even detailed photos of the interior 
would 
> > be great. I have not succeeded to get in touch with Akai here in 
> > Sweden or with Akai in Japan.
> > 
> > The other problem: My S1000 is now equiped with two internal SCSI 
> > drives. The internal SCSI cable only has two connectors, of which 
one 
> > is joined on the SCSI card by soldering. Does anyone have any 
ideas 
> > how to connect the drives?
> > 
> > Thank you very much.
> > 
> > 
> > Regards,
> > 
> > Mattias, Sweden