Analogue-sequencer

just got around to installing v4 os on my p3.

when i go in to create a pattern i dont have the option to change the tbase
or direction.
the tbase seems to be stuck at 2n & has "???" defined , see pic -

http://205.234.140.67/p3.jpg

i guess this is an error & that direction & tbase are definable by pattern?

ive loaded v4 three times since, using p3 tools in case it was an error in
the installation but same problem each time..

any ideas?

thanks


[Non-text portions of this message have been removed]

ok, my fault....didnt initialise the memory on poweron...all fixed now...





On 01/03/2008, magnetize <magnetize1@gmail.com> wrote:
>
> just got around to installing v4 os on my p3.
>
> when i go in to create a pattern i dont have the option to change the
> tbase or direction.
> the tbase seems to be stuck at 2n & has "???" defined , see pic -
>
> http://205.234.140.67/p3.jpg
>
> i guess this is an error & that direction & tbase are definable by
> pattern?
>
> ive loaded v4 three times since, using p3 tools in case it was an error in
> the installation but same problem each time..
>
> any ideas?
>
> thanks
>


[Non-text portions of this message have been removed]