Analogue systems

hi nectarios,
if you want to connect AS modules to the AS psu board
all you have to take care of is to connect the red
stripe of the ribbon cable to the "0 volts"on the
module pcb and on the PSU pcb.now,if you want to
connect AS modules to the doepfer bussboard then you
will need special converter cables.i think analogue
systems or analogue solutions can supply these cables.
as for the power requirements:
rs20:10mA
rs80:25mA
rs100:30mA
rs110:45mA
rs165:5mA

btw,are you from greece???nectarios is a greek
name!:-)
bakis.



--- nectarios01 <nectariosm@hotmail.com> wrote:
> Hi there.
> 
> I am new to this forum since I just got some AS
> modules to go on my 
> Doepfer racks. I bought the modules used and I could
> not find any 
> construction/interconnection details on the A.S.
> site.
> I wanna ask which is the right way to connect the AS
> modules on the 
> buss board? The RS110 has two red lines as well, one
> that is right 
> on the edge and one that is 3-4 wires inside. The
> red line on the RS 
> 100 is not on the edge either. Any help please?
> Can someone tell me the current requirements for the
> follwing 
> modules?
> 
> RS 20
> RS 80
> RS 100
> RS 110
> RS 165
>  
> I think I might have overloaded one of my racks and
> there is no 
> power going to the modules that are fitted on it (I
> think the +12V 
> PSU is gone...).
> 
> 
> Thank you in advance.
> 
> Peace out. 
> 
> 


=====
synthfreak(parallel worlds)
athens-greece
[Doepfer_a100] group owner

__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com