Bc2000 (for the BCF2000 & BCR2000)

Hey, you!  Thanks so much for your help n' stuff...I was so psyched to
follow these directions...and then...BAM!  My sequencers stopped
recognizing my BCF2000 (again), it's done this before - so i'm going
to use MIDI-OX to do this in bootloader mode (right? well, I'll find
out soon enough!).  

I shall return for my instructions shortly!  Thank you so much
again...Behringer should really just give you a commission (you've
probably saved them a lot of money on frustrated refunds!)...


--- In bc2000@yahoogroups.com, "ashwinkumar" <ashwinkumar_m@...> wrote:
>
> mate!!. the best way to use bcf with cubase  is in mackie emulation. 
> 
> here is a laymans way how to do it
> 
> there is one of small tutorial which was written by me for bcf users 
> on
> cubase on kvr have a look at it its the same for bcr too i post it 
> here
> 
> am able to control all the vst parameters with the knobs in the bcf
> and volume by faders for the start. i am also able to control the 
> mixer
> in host cubase in same mode (ncc)
> 
> for it the requirement is to have midiyoke and huskervu ( a software
> similar to bcfview). install midiyoke
> 
> first switch on the bcf in nnc mode by pressing 2nd button while
> powerup. now start the huskervu application( for installing this free
> utility u need ms net framework 1.1.432 which u can download by
> googling). then power up cubase sx3/ nuendo 3. in the device tab and
> device setup add mackie control as remote. configure input: bcf2000
> (01) and output as midiyoke:1 . rightclick on huskervu blue interface
> configure midi input as midiyoke:1 and midi output as bcf 2000
> 
> now press ok on device setup in cubase. huskervu must show cubase
> version and pan left right or something.
> 
> next step is to add a newproject and midi track . in track parameters
> if u have a midi keyboard configure it as in and vst as out
> 
> huskervu will show your miditracks and what vst u have chosen vst1 on
> and vst name
> 
> now for controlling the vst parameter all u need to do is press first
> encoder button and learn . huskervu will show the parameters u wanna
> constrol and page no like 01/03 . press second encoder button to 
> switch
> the page and parameter and then turn the corresponding knobs in bcf to
> change the parameter. when u turn the knobs the knob in vst also turns
> and thats all.
> 
> 
> i am yet to use the generic mode. i dunno the pros and cons of mackie
> emulation. i just know only what i have told u people. i suppose this
> is the same method used in bcr2000 as well. and i know its a little
> hard in configuring and knowing about bcf as the manual is the most
> stupidest thing i have seen in the world. speaks volumes of theory and
> and absolutely no practical applicability.
> 
> if some one can write details about how to configure this bcf 2000 in
> generic mode in a very simple way right from scratch one i would be so
> thankful. as for now i am watching this thread. if u have any
> clarification please do pm me or send a mail to draskum@ ill
> be more than willing to share what i know
>