Bc2000 (for the BCF2000 & BCR2000)

mate!!. the best way to use bcf with cubase  is in mackie emulation. 

here is a laymans way how to do it

there is one of small tutorial which was written by me for bcf users 
on
cubase on kvr have a look at it its the same for bcr too i post it 
here

am able to control all the vst parameters with the knobs in the bcf
and volume by faders for the start. i am also able to control the 
mixer
in host cubase in same mode (ncc)

for it the requirement is to have midiyoke and huskervu ( a software
similar to bcfview). install midiyoke

first switch on the bcf in nnc mode by pressing 2nd button while
powerup. now start the huskervu application( for installing this free
utility u need ms net framework 1.1.432 which u can download by
googling). then power up cubase sx3/ nuendo 3. in the device tab and
device setup add mackie control as remote. configure input: bcf2000
(01) and output as midiyoke:1 . rightclick on huskervu blue interface
configure midi input as midiyoke:1 and midi output as bcf 2000

now press ok on device setup in cubase. huskervu must show cubase
version and pan left right or something.

next step is to add a newproject and midi track . in track parameters
if u have a midi keyboard configure it as in and vst as out

huskervu will show your miditracks and what vst u have chosen vst1 on
and vst name

now for controlling the vst parameter all u need to do is press first
encoder button and learn . huskervu will show the parameters u wanna
constrol and page no like 01/03 . press second encoder button to 
switch
the page and parameter and then turn the corresponding knobs in bcf to
change the parameter. when u turn the knobs the knob in vst also turns
and thats all.


i am yet to use the generic mode. i dunno the pros and cons of mackie
emulation. i just know only what i have told u people. i suppose this
is the same method used in bcr2000 as well. and i know its a little
hard in configuring and knowing about bcf as the manual is the most
stupidest thing i have seen in the world. speaks volumes of theory and
and absolutely no practical applicability.

if some one can write details about how to configure this bcf 2000 in
generic mode in a very simple way right from scratch one i would be so
thankful. as for now i am watching this thread. if u have any
clarification please do pm me or send a mail to draskum@.... ill
be more than willing to share what i know