Thanks for the help. I presume that if I dissessemble the unit, I should be able to re-solder the contact?
Cheers,
James.
To: bc2000@yahoogroups.com
From: rpcfender@...
Date: Wed, 24 Dec 2008 23:44:07 +0000
Subject: [bc2000] Re: Broken encoder
Hi James
perhaps you have already tried this but, before launching into
stripping the thing down, can I suggest that you swap the software
parameters of an encoder that you know is working for the one that isn't.
You can program the encoder to give these sort of results. Perhaps you
could give us the parameters you have set it up with.
Another check you might like to do is to push the knob to the side and
hold it while you twist it. Try holding in different directions.
Sometimes not all the connections on the encoder are successfully
soldered during manufacture and a small amount of pressure will cause
movement and will make/break the connection on one of the lugs.
All the best
Royce
>;My top left encoder is acting very strangely, and I am assuming it is
a hardware fault.> >Rather than smoothly controlling the parameter it
is assigned too, such as the pan, it moves it in a very jerky fashion.
So when I scross right to left, the pan will move eratically, and in
fact sometimes make small movements in the opposite direction. The
acceleration on it is also messed up, and it is impossible to make an
entire sweet with one quick twist.> >I don't know if anyone else has
had a similar issue, and whether there is any chance it can be fixed?>
>;I'm assuming I need a whole new BCR :(> >James.>
perhaps you have already tried this but, before launching into
stripping the thing down, can I suggest that you swap the software
parameters of an encoder that you know is working for the one that isn't.
You can program the encoder to give these sort of results. Perhaps you
could give us the parameters you have set it up with.
Another check you might like to do is to push the knob to the side and
hold it while you twist it. Try holding in different directions.
Sometimes not all the connections on the encoder are successfully
soldered during manufacture and a small amount of pressure will cause
movement and will make/break the connection on one of the lugs.
All the best
Royce
>;My top left encoder is acting very strangely, and I am assuming it is
a hardware fault.> >Rather than smoothly controlling the parameter it
is assigned too, such as the pan, it moves it in a very jerky fashion.
So when I scross right to left, the pan will move eratically, and in
fact sometimes make small movements in the opposite direction. The
acceleration on it is also messed up, and it is impossible to make an
entire sweet with one quick twist.> >I don't know if anyone else has
had a similar issue, and whether there is any chance it can be fixed?>
>;I'm assuming I need a whole new BCR :(> >James.>
Get Windows Live Messenger on your Mobile. Click Here!