Bc2000 (for the BCF2000 & BCR2000)

--- In bc2000@yahoogroups.com, "Mark" <markwinvdb@...> wrote:
>
> --- In bc2000@yahoogroups.com, "Uwe" <tonmanns@> wrote:
> > I have a big problem, as my mentioned controllers are influencing each other in cubase. I semms to be a kind of MIDI feedback problem. The motorized fader is hanging, when BCR has a programm loaded, with Volume command assigned to a knob. 
> > Example: The volume midi command is sent from faderport to cubase, routes through the program to BCR and back to cubase, through it again to the Faderport and I get that delayed command onthe fader
> > The result is a stucked motorfader. Sometimes the fader is moving down without me touching anything!! The track stops by itself and several other bugs like this!! Semms as if more than one parameters are influencing each other. 
> > I know, that I could take out these Parameters from the BCR set, but a more elegant way was preferred.
> > 
> > Any hint?
> 
> It could be anything: Cubase might produce a loopback (but I don't know Cubase, so that's just a wild guess), or the BCR might be in an inappropriate Operating Mode, etc.
> 
> But before I start making all kind of suggestions that don't apply to your situation: can you be more specific about your setup?
> For instance:
> Which operating system are you using?
> In which Operating Mode (S/U-1/2/3/4) is your BCR?
> How do all MIDI connections run exactly?
> What's the content of the BCR preset?
> 
> Mark.
>


Hi Mark,

ok, I am running Cubase 5 under WinXP 32bit SP3, The BCR was in S1 mode when it occured ( I switched to S3 and S4 for testing, but only works partially)
BCR is connected to I/O Port 8 of my MIDEX 8, the Faderport is connected via USB.
The present setup is "Cubase Channel Control by Staffi" because it gives instant access to the EQs and sends( I eventually took out the parameters, that are present with the faderport to avoid the loopback symptom, but it still does not run smoothly).
Switching to S4 helped, that the bcr parameters don´t influence the presonus amymore, but changing a volume value on the bcr ends up in a level jump when changing it on the presonus now, because it didn´t react on bcr movement before and starts from an other level. A bit complicated, isn´t it?!

I  tried to disable the commands on the bcr that are not necessary and already covered by the presonus faderport, but Cubase still stops randomly.

Any clue, anybody..?

tonmanns