Bc2000 (for the BCF2000 & BCR2000)

--- In bc2000@yahoogroups.com, "Greg Long" <greg.web.dev@...> wrote:
> I am trying to get my BCR2000 to toggle an LED back off from
> being toggled on.
> 
> I have successfully been able to toggle a button on but not back off again.
> I have a button setup to toggle via NRPN 4 and it will toggle on if I enter
> a value the same or higher as Value2 in BCmanager.
> 
> But if will not toggle off with any value. I first tried a value lower than
> Value 1 and that did not turn off the button led and since I have tried
> every other value possible. 
> 
> Any suggestions?

I'm not sure what's going wrong here.
Are you sure the remote device is sending the correct NRPN messages?

And what button setup (parameters) are you using exactly?

In any case you should be aware of the perhaps counter-intuitive way the BCR uses the middle point between Value1 and Value2 as the "border": if the incoming value is closer to Value1 than to Value2, the LED goes ON; if it's closer to Value2, the LED goes OFF.

Hope this helps,
Mark.