Bc2000 (for the BCF2000 & BCR2000)

Thanks Mark, that's good to know. I think its not working because I am
entering the data in BC Manager Custom output. I found a workaround though
by setting up the button as a CC I can turn the led on/off and keeping my
NRPN custom message it still transmits that along with the CC that has no
effect on my synth because I have CC's off.

 

My custom message is:

 

  187   117   127 

   187    99     0   

   187    98    10 

   187     6     0     

   187    38   val

 

  

 

From: bc2000@yahoogroups.com [mailto:bc2000@yahoogroups.com] On Behalf Of
Mark v.d. Berg
Sent: Saturday, July 09, 2011 3:27 AM
To: bc2000@yahoogroups.com
Subject: [bc2000] Re: BCR2000 LED toggle from Remote MIDI software

 

  

--- In bc2000@yahoogroups.com <mailto:bc2000%40yahoogroups.com> , "Greg
Long" <greg.web.dev@...> wrote:
> I am trying to get my BCR2000 to toggle an LED back off from
> being toggled on.
> 
> I have successfully been able to toggle a button on but not back off
again.
> I have a button setup to toggle via NRPN 4 and it will toggle on if I
enter
> a value the same or higher as Value2 in BCmanager.
> 
> But if will not toggle off with any value. I first tried a value lower
than
> Value 1 and that did not turn off the button led and since I have tried
> every other value possible. 
> 
> Any suggestions?

I'm not sure what's going wrong here.
Are you sure the remote device is sending the correct NRPN messages?

And what button setup (parameters) are you using exactly?

In any case you should be aware of the perhaps counter-intuitive way the BCR
uses the middle point between Value1 and Value2 as the "border": if the
incoming value is closer to Value1 than to Value2, the LED goes ON; if it's
closer to Value2, the LED goes OFF.

Hope this helps,
Mark.