doing some desoldering, I managed to damage a pad.......
its on the top board of the bandwidth filter stack, see diagram in
cgs30 module. looking at the diagram you will see a red wire running
from the top cgs30 pcb to the +ve on the dc mixer. where the wire
connects to the top filter board theres a white line running to the
right, I assume for a link, the damaged pad is the other point of this
link. specifically, the pads fully gone, just the plastic where it
should be.
does this matter, and if so, how does one repair it.
grant
its on the top board of the bandwidth filter stack, see diagram in
cgs30 module. looking at the diagram you will see a red wire running
from the top cgs30 pcb to the +ve on the dc mixer. where the wire
connects to the top filter board theres a white line running to the
right, I assume for a link, the damaged pad is the other point of this
link. specifically, the pads fully gone, just the plastic where it
should be.
does this matter, and if so, how does one repair it.
grant