Easy, just follow the track back to the previous pad and run a small link. Works for me.
FF
FF
----- Original Message -----
From: mesonproductions
To: cgs_synth@yahoogroups.com
Sent: Tuesday, August 09, 2005 5:28 PM
Subject: [cgs_synth] damaged pad .....does it matter???
doing some desoldering, I managed to damage a pad.......
its on the top board of the bandwidth filter stack, see diagram in
cgs30 module. looking at the diagram you will see a red wire running
from the top cgs30 pcb to the +ve on the dc mixer. where the wire
connects to the top filter board theres a white line running to the
right, I assume for a link, the damaged pad is the other point of this
link. specifically, the pads fully gone, just the plastic where it
should be.
does this matter, and if so, how does one repair it.
grant
The CGS Modular Synth home page: http://www.cgs.synth.net/
------------------------------------------------------------------------------
YAHOO! GROUPS LINKS
a.. Visit your group "cgs_synth" on the web.
b.. To unsubscribe from this group, send an email to:
cgs_synth-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
------------------------------------------------------------------------------
------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.2/65 - Release Date: 07/08/2005
----------
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.5/67 - Release Date: 09/08/2005
[Non-text portions of this message have been removed]